How To Make Glasses From Bottles.

The three parts of a bottle are the neck, body and mouth with the area from the neck being slender than the rest of the body. A gob is made by cutting of a stream of molten glass from sheet glass or from glass container glass with a clipping blade to form glass cylinders using either the blow and blow process or the press and blow technique. Manufactured bottles are used for different uses such as storage of perfumes, drinks and many other tasks.

There are different procedures on how one can make glasses out of a wine bottle which includes:

Use of flame to make a glass bottle. This procedure begins by scoring the bottle to create the line that the bottle will break off at using a glass cutter or a glass drill. The second step should be to heat the bottle while rotating it regularly to ensure the heat from a small candle or a small butane torch is evenly distributed. The bottle can be dipped in cold water in a sink or in a pot full of water as the third step after the 5 minutes heating. If the bottle does not break, repeat the process of heating and cooling until it breaks off as desired. Immediately the bottle breaks off rub its edges with a square sandpaper to smother the rough edges that may cut you and eventually with a finer grit sandpaper.

Use of a yarn to cut a bottle.
First, wrap the yarn or cotton string around the bottle 3 to 5 times at the area where you would like the bottle to break, tie the ends together and cut the excesses. The string or the cotton yarn is then removed from the bottle gently and placed on a dish where nail polish remover or straight-up acetone is added over the yarn until it soaks completely while the excesses are poured into the bottle. The third step should involve returning the yarn on the location where the cut off is supposed to happen and ensuring that the yarn loops are close together and tight enough to allow a level and clean cut off. Light the yarn on fire and rotate it gently to ensure that it burns in consistency. To cut off the glass, dip it in a sink or pot full of cold water which should be after the yarn has burnt out until the glass is cut. Sand the edges with a rough sandpaper to smooth and then with a finer grit sandpaper.

3 Cutting Tips from Someone With Experience

The Art of Mastering Bottles